Charging The Battery - Craftsman Speed Start 316.859530 Operator's Manual

NO TOOLS REQUIRED!
Charger
Red LED
Keyed Tip
Trigger
This unit comes completely assembled.
UNPACKING
1. Carefully remove the product and any accessories from the box.
2. Inspect the product carefully to make sure no breakage or damage occurred
during shipping. Do not discard the packing material until you have
carefully inspected and satisfactorily operated the product.
CHARGING THE BATTERY
c o,o° o i ic tion otex es ove 1
the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radioiTV technician for help.
NOTE: The battery is not shipped fully charged. It is recommended to fully
charge the battery before use to ensure that maximum run time can be
achieved. The lithium-ion battery will not develop a memory and may be
charged at any time. A fully discharged battery will require approximately
3-5 hours to completely charge.
NOTE: Use only the supplied charger (Model # SH-DC120400, P/N 753-
06672) when charging. The use of any other charger could damage the
battery or create a hazardous condition.
1. Plug the charger into an AC wall outlet / receptacle.
2. Insert the charger into the back of the unit (Fig. 1).
3. The red LED will illuminate (Fig. 1).
4. The red LED will turn off when the battery is fully charged.
5. Disconnect the unit from the charger.
NOTE: The unit may be stored with the
charger still attached, but the charger Red LED
should be disconnected from the wall \
outlet / receptacle when doing so.
NOTE: Lithium-ion batteries, while in use,
will continue to provide full power
without power fade, unlike typical
batteries; when the battery is fully Charger
discharged, the battery circuitry will
immediately cut power to the tool and Fig. 1
require immediate charging.
IMPORTANT! DO NOT use the unit while it is charging. Doing so may
damage the unit and battery.