Advertisement
Available languages
Available languages
CASTER
INSTALLATION:
NOTE: Use adequate manpower for this
operation.
o Remove the bottom drawer. See drawer
removal instructions.
* Lay the unit on its back, use packaging
material to protect the paint finish.
- Attach the casters to unit using (4) 1/4-20
x 7/16" screws and (4) 114-20 nuts.
Mount both swivel casters on the same
side of the unit. Wrench tighten.
• Return the unit to its upright position.
OUTLET
STRIP INSTALLATION:
° Attach outlet strip to plastic top using the
screws (4) provided with the outlet strip.
PLASTIC
TOP INSTALLATION:
• Slide the two plastic top pieces together
and place on the unit.
• Attach the top to the unit using (3)
#14-10x3/4" screws and (3) 1/4"
washers. Be sure the individual tops
are snug against each other.
° Complete
top attachment
using (4)
#14-10x3/4"
screws and (4) 1/4"
washers.
• Insert plug into hole in the plastic top.
NOTE: To use this hole for cord
management, remove the center portion of
the plug before installing.
. Place wood top on the plastic top.
DRAWER
REMOVAL:
• Fully extend the drawer. Push it back a
quarter of an inch.
• Insert a screwdriver into the slot in the
slide and push in on the stop until it
clears the lance. Repeat the procedure
on the other slide and remove the drawer.
Lance
Lubricate
° To reinstall the drawer, pry the stop far
enough out to engage the lance (3/16" to
1/4") and push the drawer onto the slides
until the stops pass over the lances.
A
° For casters, use high quality bearing"
grease, (yearly).
• Lubricate the slides, (twice yearly).
° Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and water.
° Auto wax will preserve the storage unit's
luster finish. Apply the wax as to a car.
The wax will also help protect the unit
against scratches.
• Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable cleaning
fluid.
Advertisement
