Advertisement
_1,
WARNING:
Use recommended accessories.
The use of improper accessories may create a
risk of injury. Do not use this long miter/rip fence
kit for any purpose other than as an accessory to
the recommended table saw. Failureto heed this
warning can result in serious personal injury.
UNPACKING
AND CHECKING
PARTS
Your new long miter/rip fence kit includes a 41 in.
extension rail, plus the necessary gages, brackets,
and connecting hardware required to assemble a long
miter fence and attach it to the sliding miter table of
your table saw. It also includes connectors and
hardware required for attaching a long rip fence to
your saw.
Note: When used as a long miter fence this kit
temporarilyreplaces the miter fence supplied with your
saw. When used as a long rip fence it attaches to the
ripfence supplied with your saw.
Separate all parts from the packing materials. Check
the parts with the parts list and Figure 1. If any parts
are missing, delay your assembly of this kit until you
have obtained the missing part(s).
_i,
WARNING:
Do not assemble the long miter/rip
fence kit or use in any way without obtainingany
missingpads. Installall parts correctly. Failure to
heed this warning could resultin an accident and
possible personal injury.
.......
SQUARE HEADBOLT(1/2in.)
HEXBOLT 1/2 n
BRACKET
_
_
_
_
/
T-NUT
PLASTITESCREW
(WORKSUPPORT)
A
_
_
_/_'A
_
- /
MITER
S AWOAO
KNOSOOLT
L _
' _._ _
5/161n.
_
_..,_b'_i_
L 1 I
I
_
HEX BOLT
_
":t1|
SRACKET B,O.,/
v r
POSITIVE STOP)
BRACKET I SUPPORT AND
_
"'"
LEFTPOSITIVE STOP)
KNOBNUT(1/4-20)
Fig. _1
List of Loose
Parts
Your Long Miter/Rip Fence Kit includes the followingpads:
Description
Quantity
Miter/Rip Fence Rail .......................................... 1
Bracket (Support and Left Positive Stop) .......... 2
Saw Gage ..........................................................
2
Knob Bolt (5/16-16 x 1/2 in.) .............................. 1
Knob Nut (1/4-20) .............................................. 1
5/16 in, T-Nut (Special) ...................................... 6
Bolt (1/4-20 x 1/2 in. Sq. Hd.) ............................ 1
Washer (5/16 in.) ............................................... 6
Bracket (Right Positive Stop) ............................. 1
Description
Quantity
Washer (1/4 in.) .................................................
1
Plastite Screw (8-16 x 5/8 in. Pan Hd.) .............. 2
Bracket (Work Support) .....................................
1
Bolt (5/16-18 x 718 in. Hex Hal.) .........................
1
Miter Indicator ....................................................
1
Pivot ...................................................................
1
Connector ...........................................................
2
Bolt (5/16-18 x 1/2 in. Hex Hd,) .........................
4
3
Advertisement
