Advertisement
Advertisement
Owner's Manual II:RRFTSMRN'I LONG MITER/RIP FENCE KIT FOR USE WITH CRAFTSMAN 10 in. TABLE SAWS 9-22811 AN D 9-22185 SLIDING MITER TABLE (NOTINCLUDED WITHTHISKIT) Item No. _9 22217 THIS KIT MAKES EITHER A LONG MITER FENCE OR A LONG RiP FENCE FOR...
It also provides additional support and control for making LONG MITER/RIP FENCE KIT SHOWNATTACHEDTO CRAFTSMAN 10 in. TABLE SAW LONGRIPFENCE LONG MITER FENCE...
Note: When used as a long miter fence this kit WARNING: Use recommended accessories. The use of improper accessories may create a temporarilyreplaces the miter fence supplied with your risk of injury. Do not use this long miter/rip fence saw. When used as a long rip fence it attaches to the kit for any purpose other than as an accessory to ripfence supplied with your saw.
TOOLS NEEDED ATrACHMENT BOLT Tools needed for assembly of this kit are a phillips screwdriver, 1/2 in. socket wrench, or the small MITER FENCE HOLDER wrench supplied with your table saw. (Philips screw- driver and 1/2 in. socket wrench not included). MITER FENCE PHILLIPS SCREWDRIVER...
ASSEMBLE THESAWGAGES ASSEMBLE THE SUPPORT BRACKET See Figure 4. See Figures 4 and 5. The supportbracket attaches to the bottom of long SOUARE MITER/RIP FENCERAIL miter fence and sliding miter table. As the name HEADBOLT_ (LONGMITERFENCERAIL) implies it provides support and stability for the long 1/4in.
MITER/RIP FENCERAIL (LONGMITERFENCERAIL) ADJUSTING MITER FENCEHOLDER RIGHTPosmvE SLIDING STOPBRACKET LEFTPOSITIVE STOPBRACKET SUPPORT 5/16in. WASHER --"_, SQUARE HEAD BOLT(1/2in.) WORK SUPPORT BRACKET J_"_ 5/16in. WASHER 1/4in. (1/4-20) (7/8in.) KNOBNUT WASHER _KNOB BOLT Fig. 5 COMPLETED LONG MITER FENCE ASSEMBLY See Figure 6. After assembling all the parts, your long miter fence shouldbe similar to the illustrationshown in figure 6.
RAILORIENTATION FOR COMPLETED LONG RIP FENCE ASSEMBLY LONGRIP FENCESETUPS See Figure 9. PLASTITE LONG RIP FENCE ASSEMBLY SHOWN ATTACHED TO A CRAFTSMAN TABLE SAW T-NUTS MITER/RIP FENCERAIL (LONGRIPFENCERAIL) SAW GAGE Fig. 7 • Secure each saw gage to the rail with 8-16 x 5/8 in.
CRAFTSMAN LONG MITER/RIP FENCE KIT ITEM NO. _922217 Always mention the accessory item number in all correspondence regarding your long miter/rip fence kit accessory or when ordering repair parts. PARTS LIST Number Description Quan. 661815-001 Knob Bolt (5/16-18 x 1/2 in.) ................
Comments to this Manuals
Latest comments: