Craftsman 320.2767 Operator's Manual page 10

• Let the motor come to a complete stop before putting the router down.
Cutter bits coast after the power is turned off.
• Only use router tables with on-board switch-controlled receptacles.
Failure to use router tables with all the appropriate safety features could
result in serious personal injury.
• Disconnect the tool from the power source before making any adjustments
or changing cutter bits.
• If you are changing a bit immediately after use, be careful not to touch
the collet/nut or cutter bit with your hands or fingers. The heat buildup
from cutting could cause severe burns. Always use the wrench provided.
• Avoid "climb cutting;", see "OPERATION" section in this manual. "Climb
cutting" increases the chance for loss of control resulting in possible serious injury.
_I, WARNING: Bits, sockets, and tools get hot during operation. Wear gloves
when touching them.
_, WARNING: Wear ear protection. Exposure to noise can cause
hearing loss.
_I, WARNING: To avoid injury, hold the tool by the insulated gripping surfaces
only. If the tool contacts hidden wiring or its own cord, exposed metal parts
of the tool could shock the operator and cause serious injury. Make sure that
hidden electrical wiring, water pipes, or other hazards are not in the cutting path.
2767 Manual_Revised_10 1213 Page 10