Table of Contents
Advertisement
Rivingknife
(Fig. M)
Storage brackets for the riving knife are
located on the right side of the stand.
1. Remove the washer (8) and the
locking handle (10).
2. Insert riving knife (9) under the set
plate (4) and between the retaining
clip (7).
3. Tighten the washer (8) and the
locking handle (10).
Fig. M
9
i/8
INSTALLING
THE POWER CORD
STORAGE CLAMPS (Fig. N)
1. Attach the power cord storage clamp
(1) into the hole set on the rear side
of the table saw base with screw (2)
and nut (3). NOTE: The nut is placed
inside the base.
2. Repeat for the other clamp, to be
located on the bottom right on saw
base.
Fig. N
the cord. Do not wrap the power cord
around the dust port (3).
Fig. 0
1
3
2
1
ASSEMBLING THE BLADE
ELEVATION/TILT
HANDWHEEL
(Fig. P)
1. Attach the blade elevation
handwheel (1) to the elevation rod
(2) at the front of the saw. Make
sure the slot (3) in the hub of the
handwheel (1) engage with the pins
(4), turn handle 90 degrees to align
pin with the recessed slot to hold
the handle in place.
2. Attach and tighten the crown nut
(5) and washer (6) with a 13 mm
wrench.
Fig. P
4
1
front view
Power cord (Fig. O)
Wrap the power cord (2) onto the
storage clamps (1) when saw is not
in use. This can prevent damage to
22
Hide quick links:
Advertisement
Table of Contents
