Operating The Projector With The Remote Control - Epson PowerLite 51c User Manual

2. Insert the two AA batteries
included with the projector
as shown.
3. Replace the battery cover.
Operating the Projector with the Remote
Control
1. Push up the switch on the side of the remote control to turn
R/C
it on.
2. Point the remote at the front of the projector or at the screen.
3. Press the button for the function you want to use. The light next
to the button on the remote control flashes briefly. (If
Power
it doesn't flash, you may have inserted the batteries incorrectly or
need to change the batteries; see page 32 for instructions.)
The projector may not respond to remote control commands in these
conditions:
You are too far away or not within a 30° horizontal or 15° vertical
I
angle of the projector's sensor
The switch on the right side of the remote control is in the
I R/C
position (the remote control is turned off)
OFF
I Batteries are weak
I Bright ambient light, fluorescent light, or direct sunlight is
shining into the remote control sensor
Equipment emitting infrared energy (such as a radiant room
I
heater) is nearby and interfering with the sensor
caution
When replacing batteries,
take the following
precautions:
I
Replace batteries as soon
as they run out.
I
Do not mix old and new
batteries.
I
If the batteries leak, wipe
away battery fluid with a
soft cloth. If fluid gets on
your hands, wash them
immediately.
I
Remove batteries if you
will not be using the
remote for a long period
of time.
power
indicator
light
R/C switch
Using the Projector
33