The Laser Guide - Craftsman 137.212360 Operator's Manual

NOTE: Mountinghardware is not includedwith
thistool. Bolts, nuts, washers, and screws must
be purchas_l separately.
2. For portable use, place the saw on a 314 in.
thickpiece of plywood.Boltthe base of the
miter saw securely to the plywoodusingthe
mounting holes on the base. Use C-clamps
to clamp this mountingboard to a stable work
surface at the worksite.
Fig. Q
Inch Plywood
Hand Hold for
Transportation /
THE LASER GUIDE (RG. R)
1. To turn laser on, tum switch(1)to "1"position.
2. To turn laser off, turn switchto "O" position.
Fig. R+
Your tool is equipped with the Laser Guide
usinga Class III laser beam. The laser beam will
enable you to preview the sew blade path on
the stock to be cut beforestartingthe miter saw.
This laserguide is powered by two AAA 1.5 volt
batteries.
Laser Warning Label:
Max output <SmW DIODE LASER:
IS30-670nm, Complies with 21CFR 1040.10
and 1040. 11.
_ FIADWION
AVOIO I_'T EYEEXPO_IE OR_
DmL_TLY WfllH 0PTiCAL Bd81RUMBMT_
C_ _1_ 21CFR 10S.10 I',d 10W.ll
\._ Cl*n k L_er Produd •
I& WARNING I
• Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
I A
WARNING J
• The use of optical Instruments with this
product will increase eye hazard.
• Do not attempt to repair or disassemble
the laser. If unqualified persons attempt
to repair this laser product, serious injury
may resuIL Any repair required on this
laser product should be performed by a
Sears or other qualified service center.
NOTE: All the adjustments for the
operation of this machine have been
completed st the factory.
AVOID DIRECT EYE CONTACT
A WARNING I
• Laser is radiated when laser guide is
turned on. Avoid direct eye contact.
Always un-plug the miter sew from power
source before making any adjustments.
17 IIIIII