Sears 113.239201 Owner's Manual page 12

k i_
:ii:i¸_ _ ;¸¸ :
!:!_-_:_i/:_::i: ¸¸!,I:I/i _ _ .:_ _;:; :_::: _` :;_; _ ::_:::_;;j_
...... Aiign the guard _pportl _0 that it is:cer_teredon the shaper
spind e i(It may_ibe necessary to ioosen: the 5/16:18 ScreWs
Which: secure _the ii Support bracket :tO the channeis ito
perform this adjustment):; Af{er the :alignment is achieved
tighten all four SCrewS securely.
InStall Cutter GUard:Assembly to table support using the
two 5/16:18 X:2 inch hex head screws located at rear of
table Support.
GUARD
k
]2