Starting; How To Use; Operation; Pressure Washer Location - Craftsman 580.752870 Operator's Manual

HOWTO USEYOURPRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
PressureWasher Location
PressureWasher Clearance
,&. WARNING Exhaust heat/gases could ignite
combustibles, structures or damagefuel tank
causing a fire, resulting in death, serious injury
and/or property damage.
= Keep at least5 ft. (1.5m) clearance on all sidesof pressure
washerincludingoverhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
_ressure washer.
,&. WARNING Running engine gives off carbon
monoxide, an odorless, colorless, poison gas.
_ Breathing carbon monoxide could result in death,
serious injury, headache, fatigue, dizziness,
vomiting, confusion, seizures, nausea or fainting.
• Operatethis product ONLY outdoors.
= Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
• DO NOToperate this product inside any building, carport,
porch, mobile equipment, marine applications, or enclosure,
even if windows and doors are open.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the first
time, follow these instructions step-by-step. This information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at least a day.
1. Place pressure washer outside near an water source
capableof supplying water at a flow rate greater than
3.3 gallons per minute and no less than 20 PSi at
pressure washer end of garden hose.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. See Assembly for illustrations.
3. Make sure unit is in a level position.
4. Connectgarden hose to water inlet on pressure washer
pump.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
= Damage to equipment r esulting from failureto followthis
instruction will voidwarranty.
5. Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
6. Attach nozzleextension to spray gun. Tighten by hand.
7. Choose spray tip you want to use, pull back on collar of
nozzle extension, insert spray tip and releasecollar. Tug
on spray tip to make sure it is securely in place. See
How to Use Spray Tips.
8. Push
engine
rocker switch (B) to on
position (I or ON).
12