Printing Method; Feeding And Printing Paper By Hand - Epson TM-C100 Technical Reference Manual

3.1.2.2 Printing method

1. Check the following 3 points before printing.
• The printer is turned on
• The release lever is up
• Paper is set in the roll paper holder
2. When a print command is sent from an application, the printer prints the data.
Note:
During printing, do not press the release lever. If you press the release lever to release it during
printing, printing stops and all the print data is lost.
Settings for cutting the roll paper, margins and so on are all made in the driver. See the driver manual
for details.
If you open the printer cover during printing, printing is paused. When the printer cover is closed,
printing restarts.

3.1.3 Feeding and printing paper by hand

Note:
You cannot hand feed paper for printing with the roll paper specification printer when the roll paper
holder is installed. Turn the power off, and remove the roll paper holder first.
For information on how to set the driver, see the driver manual.
1. Set paper feed in the driver to "Hand feed."
2. A print command is sent from the driver.
Note:
With the ASF (auto sheet feeder) specification printer, paper that is hand-fed without a print
command from the printer is ejected. Always send a print command from the driver first.
3. Check that the printer is waiting for paper (the PAPER LED is flashing), and lower the
release lever to release it.
4. Insert the paper into the slot on the right side of the printer, and align the edge of the paper
with the leftmost side.
3-4 Using the Printer Rev. C