Table of Contents
Advertisement
A.4 ASF Specification
Item
Cut sheet feeder specifications Paper feed type:
Paper specifications
Feed specifications
Mass
Note:
The paper must be flat, without curls or wrinkles (especially at the top edges). Otherwise, the paper may
rub against the nozzles and be soiled.
When printing envelopes, curls or wrinkles may occur because of the sealing method, shape, material and
so on, causing feed and printing errors; therefore prior evaluation is necessary.
In order for cut sheet detection to work properly, do not use paper that has cutouts or holes. However, as
shown in the following figure, holes and cutouts of the "permissible hole and cutout size" in the "hole and
cutout permissible area" are permissible.
* Hole and cutout outside the "hole and cutout perm issible area" are not
Rev. C
Specification
ASF unit detection:
Cut sheet detection: Detection by the TOF/BOF sensor
Paper type:
Paper size:
Paper thickness: 0.08 to 0.25 mm
Basic weight:
Number of sheets set: Combined paper thickness 5.5 mm or less (including
Approximately 1.9 kg
hole and cutout
perm issible area
hole and cutout
perm issible size
11 or less
Cut sheet hole permissible area
TM-C100 Technical Reference Guide
Friction feed
Detection by an optional connector
Plain paper/special paper (special fine paper, special matte
paper)/plain borderless label paper
55 to 135 mm (width) × 85 to 210 mm (length)
2
64 to 218 g/m
(JIS P8124)
(55 to 188 kg / 1,000 sheets / 788 × 1,091 mm)
unevenness in the paper)
20 sheets or less (with paper thickness of 0.25 mm)
50 sheets or less (with paper thickness of 0.10 mm)
3 or m ore
[Unit: m m , all values are typical]
Product Specifications of the TM-C100 A-7
Advertisement
Table of Contents
