Craftsman 172.27696 Owner's Manual page 5

TOOL USE AND CARE SAFETY CONT.
.....................................
Z_WARNING:
USE OF ACCESSORIESTHAT ARE NOT RECOMMENDED
FOR USE WITH THIS TOOL MAY CREATE A HAZARDOUS CONDITION.
8. ALWAYS use only accessories that are recommended for this tool.
Accessories that may be suitable for one tool can become hazardous
when used on another toolo
i
SERVICE SAFETY
1. If any part of this sander is missing or should break, bend, or fail in any way;
or should any electrical component fail to perform properly: ALWAYS shut off
the power switch and remove the saw plug from the power source and have the
missing, damaged or failed parts replaced BEFORE resuming operation.
2. Tool service must be performed only at a Sears Service Center. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
SAFETY RULES FOR SANDERS
1. NEVER use this or any power sander for wet sanding or liquid polishing,
Failure to follow this rute will increase the risk of electrical shock,
ADDITIONAL RULES FOR SAFE OPERATION
, ,, ,,,, ,, , ,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
_WARNING:
BE SURE to read and understand all instructions. Failure
to follow all instructions listed below may result in electric shock, fire and/or
serious personal injury.
i l lll i,i J/ill J J J J i iJl/iJll JJi Jii
1. Know your power tool. Read operator's manual carefully. Learn the
applications and limitations, as well as the specific potential hazards related
to this tool.
2. ALWAYS wear safety glasses or eye shields when using this sander.
Everyday eyeglasses have only impact-resistant lenses; they are NOT safety
glasses.
3. ALWAYS protect your lungs.Wear a face mask or dust mask if the operation
is dusty.
4. ALWAYS protect your hearing.Wear hearing protection during extended
periods of operation.
5. ALWAYS inspect the tool cords periodically and if damaged have them
repaired at your nearest Sears Service Center or other qualified Service
Facility, ALWAYS be aware of the cord location.
6. ALWAYS check for damaged parts. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine if it will
operate properly and perform its intended function. Check for misalignment
or binding of moving parts, breakage of parts, and any other condition that
may affect the tool's operation. A guard or other part that is damaged,
should be properly repaired or replaced at an qualified Service Center.