Advertisement
Available languages
Available languages
GENERAL
I Z_ WARN
ING:
T° av°id accidents' ALWAYS disc°nnect the t°°l fr°m the
1
power source BEFORE cleaning or performing any maintenance°
/_, WARNING:
When servicing a tool, ALWAYS use only identical
replacement parts, Use of any other parts may create a risk of electric shock or
injury and cause product damage.
All parts represent an important part of the double insulation system and should be
serviced only at a Sears Service Center.
Avoid using solvents when cleaning plastic parts° Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, carbon dust, etco
WARNING:
DO NOT at any time letbrake fluids, gasoline, petroleum-based
products, penetrating oils, etc. to come in contact with plastic parts.They contain
chemicals that can damage, weaken or destroy plastic. Use clean cloths to remove
dirt, carbon dust, etco
It is a known fact that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fiber glass,
wallboard, spackling compounds or piaster.The chips and grindings from these
materials are highly abrasive to electrical tool parts, such as bearings, brushes,
commutators, etc Consequently, it is not recommended that this tool be used for
extended work on any fiber glass material, wallboard, spackling compound, or
plaster. During any use on these materials, it is extremely important that the tool is
cleaned frequently by [blowing with an air jet.
EXTENSION CORDS
The use of any extension cord will cause some tossof power. To keep the loss at a
minimum and to prevent overheating, use an extension cord that is heavy enough to
carry the current that the tool will draw°
A wire gauge (_,;WG)of at least 16 is recommended for an extension cord 100 feet
or less in length. When working outdoors ALWAYS use an extension cord that is
suitable for outdoor use.The cord's jacket will be marked WAo
i
=
L
I Z_ CAUTION:
Keep
extension cords away from the cutting area, and position
I the cord so it will not get caught on lumber, tools, etc. during the cutting operation_
WARNING:
Check extension cords before each use. If damaged, replace
it immediately_ N EVER use a toolwith a damaged cord because touching the
damaged area could cause electrical shock, resulting in serious injury
=
=
16
Advertisement
