Contents; Rules For Safe Installation And Operation - Craftsman 390.2532 Owner's Manual

CONTENTS
INTRODUCTION/WARRANTY .................................. 2
MAJOR COMPONENTS .............................................. 3
PUMP PERFORMANCE ............................................... 4
INSTALLATION ........................................................ 4-8
ELECTRICAL ............................................................ 8-9
OPERATION ........................................................ 10-11
HELPFUL HINTS / MAINTENANCE ..................... 11-14
TROUBLESHOOTING GUIDE .................................. 15
REPAIR PARTS ..................................................... 16-19
INTRODUCTION
Please read our instructions before installing and using
your Deep Well Jet Pump. This will help you obtain the
full benefits of the quality and convenience built into
this equipment. It will also help you avoid any needless
service expense resulting from causes beyond our con-
trol which are not covered by our warranty.
RULES FOR SAFE INSTALLATION AND OPERATION
Carefully read and follow all safety instructions in this
manual or on pump
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury!
Warns about hazards that will cause seri-
ous personal injury, death or major property damage if
ignored.
[AWARNING] Warns about hazards that will or can
cause serious personal injury, death or major property
damage if ignored.
[_
CAUTION
] Warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions
which are important but not related to hazards.
1. To avoid risk of serious bodily injury and property
damage, read safety instructions carefully before in-
stalling pump.
2. Follow local and/or national plumbing and electri-
cal codes when installing pump.
3. Keep well covered while installing pump to prevent
leaves and other debris from falling into well, con-
taminating well and possibly damaging pump.
4. Protect pump and piping system from freezing.
Allowing pump or water system to freeze could
severely damage pump and voids warranty.
[AWARNING] To avoid serious injury and equip-
ment damage, limit system pressure to 100
pounds per square inch (PSI) or below at all
times. Over-pressure can cause tank blowup; in-
stall relief valve capable of passing full pump vol-
ume at 100 PSI.
5. With a new well, test well for purity before use.
Consult local Health Department for procedure.
[AWARNING_Hazardous
voltage. Can shock, burn,
cause death, or start fires.
6. Disconnect electrical power source before in-
stalling or working on pump.
7. Ground pump with a ground wire nan from ground-
ing lug on motor to a grounded lead in the service
panel.
8. Line voltage and frequency of electrical power sup-
ply must agree with motor nameplate.
9. Use of fuses or wire smaller than size recommended
in owner's manual can cause overheating, possible
fires, and will void warranty.
10. This pump is a deep well jet pump. It is not de-
signed or intended for shallow well use. Use in a
deep well (more than 25' depth to water).