Table of Contents
Advertisement
bulb. The lighting system is a safety
component, please pay more attention
on the replacement of it and ensure that
any detail must be proper in case of
replacement. Get to the Chery's special
service station to have it repaired, if
necessary.
Position Lamp Holder
Turn Signal
Lamp Holder
Low Beam Holder
The position lamp bulb can't be
replaced. If the bulb fails to work,
please immediately get to the Chery's
special service station to have it
repaired.
Front fog lamp bulb
Please get to the Chery's special
service station to replace the front fog
lamp bulb.
Tail lamp bulb
Stop Lamp Holder
High Beam
Holder
1.
Open the tail door, and unscrew
the two nuts (under the plate
guard) used to fix the tail lamp
from the internal side of luggage
boot
in
the
direction. Then, unscrew three
fixing bolts from the tail lamp in
Emergency Procedures
the
remove the harness connector
from the tail lamp, and take out
the tail lamp.
2.
Unscrew the protecting hoods
from
anticlockwise direction according
to the position as shown in the
diagram.
3.
Remove the harness connector
Turn Signal Lamp
from the bulb, press downward
Holder
the clip of bulb holder by hand so
as to make the clip get through
the location groove and split
towards the both sides, take out
the bulb, and pay more attention
to the location mark of the bulb.
anticlockwise
4.
CAUTION：DO NOT touch the
surface of new bulb by hand in
anticlockwise
direction,
the
bulb
in
the
130
Advertisement
Table of Contents
