Kenmore 464424312 Use & Care Manual page 82

Troubleshootlng (continued)
Burner(s) will not light
using ignitor.
(See Electronic Ignition
Troubleshooting also)
Burner(s) will not
match light.
Sudden drop in gas
flow or low flame.
Flames blow out.
Flare-up.
ELECTRONIC IGNMON:
No spark, no ignition noise.
No spark, some ignition noise.
Sparks, but not at electrode or at full
strength.
See _GAS ISSUES:" on previous page.
Match will not reach.
Improper method of match-lighting.
Out of gas.
Excess flow valve tripped.
Vapor lock at coupling nut/LP cylinder
connection.
High or gusting winds.
Low on LP gas.
Excess flow valve tripped.
Grease buildup.
Excessive fat in meat.
Excessive cooking temperature.
Grease trapped by food buildup
around burner system.
Burner and/or burner tubes are
blocked.
Some dealers have older fill nozzles
with worn threads.
Grease buildup or food particles in
end(s) of carryover tube(s).
See Section I of Electronic Ignition System.
See Section II of Electronic Ignition System.
See Section III of Electronic Ignition System.
Use long-stem match (fireplace match).
See _Match-Lighting" section of Use and Care.
Check for gas in LP cylinder.
Turn off knobs, wait 30 seconds and light grill. If flames are still
low, turn off knobs and LP cylinder valve. Disconnect regulator.
Reconnect regulator and leak-test. Turn on LP cylinder valve,
wait 30 seconds and then light grill.
Turn off knobs and LP cylinder valve. Disconnect coupling nut
from cylinder. Reconnect and retry.
Turn front of grill to face wind or increase flame height.
Refill LP cylinder.
• Refer to _Sudden drop in gas flow" above.
• Clean burners and inside of grill/firebox.
• Trim fat from meat before grilling.
• Adjust (lower) temperature accordingly.
Persistent grease fire. • Turn knobs to OFF. Turn gas off at LP cylinder. Leave lid in
position and let fire burn out. After grill cools, remove and clean
all parts.
Flashback... • Turn knobs to OFF. Clean burner and!or burner tubes. See
(fire in burner tube(s)), burner cleaning section of Use and Care.
Unable to fill LP • The worn nozzles don't have enough _bite" to engage the valve.
cylinder. Try a second LP dealer.
One burner does not • Clean carry-over tube(s) with wire brush.
light from other
burner(s).
26°464424312°464424512