Lexmark Optra E310 Technical Instructions page 2

2
Notes
Photo 7
Need trust-worthy, detailed Technical
Instructions for another engine?
Visit: www.futuregraphicsllc.com
Photo 4
Photo 5
Photo 6
Photo 8
Photo 9
Lexmark Optra E310 Technical Instructions
Step 4
Using dry compressed air or a vacuum,
clean out both sections of the cartridge.
Step 5
Remove the three screws holding the end
caps on each side of the cartridge.
(See Photos 4 and 5)
Step 6
Remove the drum shutter arm from the
contact end cap, rotate the drum shutter
up towards the handle on the cartridge
until the tab on the shutter fits through the
notch on the end cap.
NOTE: Let the shutter dangle; Do not
remove the shutter from the other end
cap.
Step 7
Pull the contact end cap from the side of
the cartridge.
(See Photo 7)
NOTE: Do not lose the white bearing that
fits on the foam feed roller axle
(See Photo 8)
Step 8
Located ONLY on the contact end cap of
the fax cartridge is a blown 100m fuse. This
fuse must be replaced each time this car-
tridge is recycled. Replace the fuse.
(See Photo 9)
(See Photo 6)