Brother MFC-9130CW Basic User's Manual page 118

Error Message
1
Drum End SoonX
1
(X) shows the drum
unit color that is near
the end of its life.
(BK)=Black,
(Y)=Yellow,
(M)=Magenta,
(C)=Cyan.
Drum !
Drum Stop
Fuser Error
Jam 2-sided
Jam Inside
Jam Manual Feed
Jam Rear
Jam Tray
Limit Exceeded
Log Access Error
Low Temperature
104
Cause
The drum unit for the color
indicated on the Touchscreen
is near the end of its life.
The corona wires on the drum
units must be cleaned.
The drum unit or the toner
cartridge and drum unit
assembly is not installed
correctly.
It is time to replace the drum
unit.
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
The fuser unit is too hot.
The paper is jammed
underneath the paper tray or
the fuser unit.
The paper is jammed inside the
machine.
The paper is jammed in the
manual feed slot of the
machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The print limit set in Secure
Function Lock 2.0 was
reached.
The machine could not access
the print log file in the server.
The room temperature is too
low for the machine to operate.
Action
Order a new drum unit for the color indicated on
the Touchscreen before you get a Replace
DrumX message.
Clean the corona wires on the drum units (see
Cleaning the corona wires on page 82).
Put the toner cartridge into the drum unit that is
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
Replace the drum unit for the color indicated on
the Touchscreen. (see Replacing the drum
units on page 86).
Press and hold down
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
See Paper is jammed underneath the paper
tray on page 121.
See Paper is jammed inside the machine
on page 118.
See Paper is jammed in the manual feed slot
on page 114.
See Paper is jammed at the back of the
machine on page 116.
See Paper is jammed in the paper tray
on page 114.
Call your administrator to check your Secure
Function Lock Settings.
Call your administrator to check the Store Print
Log to Network settings.
For more information, see Network User's
Guide: Store Print Log to Network
Increase the room temperature to allow the
machine to operate.
to turn the machine