Gigabyte GA-GC330UD User Manual page 20

9) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, and system status indicator on the chassis front panel to
this header according to the pin assignments below. Note the positive and negative pins before
connecting the cables.
• MSG (Message/Power/Sleep LED):
System Status LED
S0
S1
S3/S4/S5
• PW (Power Switch):
Connects to the power switch on the chassis front panel. You may configure the way to turn off
your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management
Setup," for more information).
• HD (Hard Drive Activity LED)
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard
drive is reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the
computer if the computer freezes and fails to perform a normal restart.
• NC:
No connection
The front panel design may differ by chassis. A front panel module mainly consists of
power switch, reset switch, power LED, hard drive activity LED, and etc. When connecting
your chassis front panel module to this header, make sure the wire assignments and the pin
assignments are matched correctly.
GA-GC330UD Motherboard
Connects to the power status indicator on the chassis front panel. The
LED is on when the system is operating. The LED keeps blinking when
On
the system is in S1 sleep state. The LED is off when the system is in
Blinking
Off S3/S4 sleep state or powered off (S5).
PW-
Power Switch
PW+
MSG-
Message LED/
MSG+
Power/
Sleep LED
- 20 -
10 9
NC
RES+
Reset Switch
RES-
HD-
Hard Drive
HD+
Activity LED
2 1