Table of Contents
Advertisement
[SCAN DENSITY]
Press this key to select a read density. The default is the same as the default copy
mode.
When the original document is being read, you can change the density, but you cannot
select [AUTO] in the process.
[LENS MODE]
Press this key to change the magnification ratio at which the original document is read.
You can select [ZOOM], [RE] or [1:1]. [RE] is the same as the default copy mode.
[ZOOM] range in each resolution are as follows:
200 dpi:
0.66 - 4.00
300 dpi:
0.44 - 4.00
400 dpi:
0.33 - 4.00
600 dpi:
0.33 - 2.00
[SCAN SIZE]
Press this key to select the scanning paper size.
Available only when using the Platen mode. You can select [AUTO] or [SIZE SETTING].
[AUTO]:
Same as the default copy mode
[SIZE SETTING]:
Allows you to select a scanning frame size.
Example:
Options:
Default is [AUTO].
[QUALITY]
Use this feature to select the resolution. You can select [600 dpi], [400 dpi], [300 dpi] or
[200 dpi].
[ROTATION]
Use this feature to rotate the original image automatically by 90 degrees counterclock-
wise. The default is [ON].
In scanner mode, a print job is not sent from the print controller. When the
scanner function is not used, it is recommended to set up the printing system in
print mode or copy mode. When AUTO RESET is available, control panel mode
setting became in copy mode automatically.
When an 11" x 17" original is loaded and you select 8.5" x 11",
then the scanning takes on the 8.5" x 11" frame.
11" x 17", 8.5" x 14", 8.5" x 11" R, 8.5" x 11", A3, A4R, A4, A5,
B4, B5R, B5, B6R, All - image area
PS-1 (Printing System (1) PostScript option) 5-7
Chapter 5 Scanner Operation
Advertisement
Table of Contents
Troubleshooting
