Download Print this page

Panasonic Omnivision VHS PV-4905 Operating Instructions Manual page 23

Advertisement

HELPFUL
HINTS
16
A
RE-RECORDING
(TAPE DUPLICATION)-
USING THE SYNCHRO
EDIT FEATURE
With only the PAUSE Button on the editing VCR, you can control two table-type
VCRs, one Movie, or a combination of these,
when you use their Synchro Edit jacks to copy a tape. The SYNCHRO
EDIT feature starts both the source and editing units
together
with the press of one button
and pauses
an ongoing playback
and recording.
EDITING
CONNECTION
SOURCE
Synchro
Edit Cord (optional)
Synchro
Edit
Edit/Remote
Jack
Jack
Video
OPERATION
Adaptor Connector
Audio Out
On The Source
Unit
1) Insert the master
tape into the Movie or the VCR.
2) Press PAUSE/STILL
where you want to start the playback
of the master
recording
to copy it.
The Source
unit is now in PLAY/PAUSE.
On The Editing
Unit
3) Insert the blank tape (or one you want to record over) into
the Moyie or the VCR.
4) Press PAUSE/STILL
where
you want recording
to begin
to make the copy of the master tape.
The Editing
unit is now in PLAY/PAUSE.
5) Press the PLAY and REC Buttons
together.
The unit is
now in RECORD/PAUSE.
The SYNCHRO EDIT feature simultaneously releases the Pause mode on both units, so playback and recording begin at the
same time.
TO SYNCHRO EDIT
6) On the Editing unit, press PAUSE to begin the re-recording (both units begin operation).
7) Press PAUSE on the Editing unit at the end of the recorded sequence (the source unit goes into PLAY/PAUSE).
8) Press the STOP Button on each VCR to stop Dubbing after completion.
B
RE-RECORDING-
IF EITHER VCR DOES NOT HAVE A SYNCHRO
EDIT JACK
Dubbing from any VHS recorder
to another is simple
and can be done using the connections and steps shown below.
CONNECTION
Source
VCR
Editing
VCR
TV Set
_.
FROM
AUDIO
OUT TO AUDIO
IN
'
_.
(Used for monitoring)
FROM
VIDEO
OUT TO VIDEO
IN
CH 3 or 4
AT THE SOURCE
VCR
AT THE EDITING
VCR
TO PLAY THE MASTER
AND RECORD
A COPY
Insert a pre-recorded
_,_
Insert a blank tape.
o_
Press the PLAY Button on the source VCR
'
tape.
'_'
AND
Press the RECORD
and PLAY Buttons
on the editing
VCR all at the same time.
Be sure to locate the desired
point on the tape.
CAUTION:
Unauthorized
exchanging
and/or copying
of copyrighted
recordings
may be copyright
infringement.
TO MONITOR
THE RE-RECORDING
PROCESS
ON YOUR
IV
• Turn TV ON and select
its VCR channel
(either CH 3 or CH 4).
• Set the VCR/TV
Selector
on the editing
VCR to "VCR".

Advertisement

loading