Panasonic HDC-TM700P Operating Instructions Manual page 73

[WIND NOISE CANCELER]
This will reduce the wind noise coming into the built-in microphones while maintaining the
realism.
• Change the mode to _!_ •
• Switch to Manual Mode. (-) 82)
: [RECORD SETUP] _ [WIND NOISE CANCELER] _ [ON] I
I
• When switching to Intelligent Auto Mode, [WIND NOISE CANCELER] is set to [ON], and the
setting cannot be changed.
• You may not see the full effect depending on the recording conditions.
• If wind sound cannot be reduced with the Wind noise canceler function alone, set [BASS
SETTING] to [LOWCUT]. (-,) 75)
[MIC SETUP]
Recording setting of the built-in microphone can be adjusted.
• Change the mode to _ .
• Switch to Manual Mode. (-) 82)
: [RECORD SETUP] _ [MIC SETUP] _ desired setting I
I
[SURROUND]:
[ZOOM MIC]:
[FOCUS MIC]:
[STEREO MIC]:
Sound is recorded with 5.1 ch surround microphone.
3irectivity of the microphone is synchronized with the zoom
operation. Sounds near the front of the unit are recorded more
clearly if you zoom in (close-up) and surrounding sounds are
recorded more realistically if you zoom out (wide angle).
Directivity of the center is enhanced for recording audio
near the front of the unit more clearly.
Sound from two directions is recorded in 2 ch by forward-
facing stereo microphones.
• If you wish to record higher quality sound and maintain realism even when zooming in, for
instance, when recording a music recital, we recommend setting [MIC SETUP] to
[SURROUND].
73
VQT2M75