Quick Guide; Inserting/Removing - Panasonic HDC-TM700P Operating Instructions Manual

Quick Guide
• Charging the battery
Charging lamp
[CHARGE] O
Chaiging
Lights up:
Goes off:
"_ Charging completed
O Connect the AC cable to the AC adaptor
and the AC outlet.
I_ Insert the battery into the AC adaptor by
aligning the arrows.
• Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
O Insert the battery until it clicks and locks.
• Inserting/removing an SD card
Access lamp [ACCESS] O
• When this unit is accessing the SD
card or bui!t, in memory , the access
lamp lights up.
1) Open the LCD monitor.
• Check that the access lamp has gone off.
2) Open the SD card/terminal cover and
insert (remove) the SD card into (from)
the card slot.
• Face the label side Q in the direction
shown in the illustration and press it
straight in as far as it will go.
• Press the center of the SD card and then
pull it straight out.
3) Securely close the SD card/terminal
cover.
• Securely close it until it clicks.
• Turning the unit on/off
Turning the power on and off with the
power button
Press the power button to turn on the power.
®/I
O The status indicator lights.
• To turn offthe power, hold down the power
button until the status indicator goes off.
Turning the power on and off with the
LCD monitor/viewfinder
Opening the LCD monitor or extending the
viewfinder turns on the power. Closing the
LCD monitor/viewfinder turns off the power.
To turn on the power
O The status indicator lights on.
13
VQT2M75