Panasonic HDC-TM700P Operating Instructions Manual page 28

When using anSD card n ot from Panasonic, orone previously used onother equipment,
for t he first time o n this u nit, format the SD card. (-)51 )When the SD card i sformatted, all
ofthe recorded data i sdeleted. Once the data i sdeleted, itcannot be restored.
Caution:
Check that the access lamp has gone off.
Access lamp [ACCESS]
• When this unit is accessing the SD card or
bui!t,in memory, the access tamp lights up,
1
Open the LCD monitor.
2
Open the SD card/terminal
cover and insert (remove) the
SD card into (from) the card
slot.
• Face the label side Q in the direction
shown in the illustration and press it
straight in as far as it will go.
• Press the center of the SD card and then
pull it straight out.
3
Securely close the SD card/
terminal cover.
• Securely close it until it clicks.
• Do not touch the terminals on the back of
the SD card.
• Do not apply strong shocks, bend, or drop
the SD card.
• Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
• When the card access lamp is lit, do not:
Remove the SD card
Turn the unit off
Insert and remove the USB cable
Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or
this unit.
• Do not expose the terminals of the SD
card to water, garbage or dust.
28
VQT2M75
• Do not place SD cards in the following areas:
In direct sunlight.
In very dusty or humid areas.
Near a heater.
Locations susceptible to significant
difference in temperature (condensation
can occur).
Where static electricity or
electromagnetic waves occur.
• To protect SD cards, return them to their
cases when you are not using them.
• About disposing of or giving away the SD
card. (,_ 144)