Panasonic HDC-TM700P Operating Instructions Manual page 51

Please be aware that ifamedium isformatted, then a ll t he data r ecorded on the medium will be
erased and c annot berestored. Back up important data o n aPC, DVD disc e tc. (_ 109, 117)
1 Touch [FORMAT MEDIA].
2 [HDC-TM700]
Touch [SD CARD] or Touch [SD CARD] or [HDD].
[Built-inMemory].
• When formatting is complete, touch [EXIT] to exit the message screen.
• Perform a physical formatting of the SD card when the SD card is to be disposed/
transferred. (-_ 144)
• Perform a physical formatting of the built-in memory/HDD when this unit is to be disposed/
transferred. (-_ 142)
• Do not turn this unit off or remove the SD card, while formatting. Do not expose the unit to
vibrations or shock.
Use this unit to format media.
Formatting built-in memory or HDD is only available with this unit.
Do not format an SD card using any other equipment such as a PC. The card may
not be used on this unit.
The amount of space left on the SD card, the built-in memory and HDD can be checked.
(Only when the mode is at the [] position)
• Touching [CHANGE MEDIA] switches the unit between the display for the SD card and the
display for the built-in memory/HDD.
• Touch [EXIT] or press the MENU button to close the indication.
• The SD card, built-in memory or built-in HDD requires some space to store information and
manage system files, so the actual usable space is slightly less than the indicated value.
The usable built-in memory/HDD space is generally calculated as 1 GB=1,000,000,000
bytes. The capacities of this unit, PCs and software are expressed as
1 GB=1,024x 1,024x 1,024=1,073,741,824 bytes. Therefore, the indicated value of the
capacity appears to be smaller.
Perform the touch screen calibration if a different object to the one touched is selected.
1 Touch [CALIBRATION].
• Touch [ENTER].
2 Touch the [+] that appears on the screen with the supplied stylus pen.
• Touch [+] in sequence (up left _ down left _ down right _ up right _ center).
3 Touch [ENTER].
• Calibration cannot be performed when the LCD monitor is turned 180 °.
51
VQT2M75