Panasonic Omnivision VHS PV-M2046 Operating Instructions Manual page 20

- V CR Plus+ Set Up
_'"_ timer programming only.
In order for your Combinatiorl VCH to do a VCH Plus+ leculding (see top o| page 21 for explal_atiol_ o| VCR Plus+), o_ a timer
recording of cable stations, some setup is required. First, find the antenna or cable connection that matches yours. Then, follow
the instructions below for your connection.
Choose your Connection Type
(Then, follow the instructions under the diagram.)
[ Connection Type A )
<CABLE BOX "* COMBINATION VCR>
Back of
FromCable Comb nation VCR .. (_
Cable Box _ .... ] Antenna ip
(supplied) " :::::::_
@vj.o @..o,0....
VIDEOIN AUDIO IN
.,o.to, @ @
I
Combination VCR
If your system looks like this diagram,
do the following.
1. Complete the "Cable Box Set Up"
section at right.
2. Skip page 21 and go directly to page
22 for VCR Plus+ Programming.
I Connection Type B )
<CABLE or ANTENNA -_ COMBINATION VCR>
Back of
Combination VCR
Cable Box Set Up
For connection A (see left) only
O
MENU
Push MENU to
display the menu.
Rotate and push
_ the WHEEL
to select "CH."
MAIN MENU
CH CLOCK EXIT
SELECT : ROTATE WHEEL
SET : PUSH WHEEL
Rotate and push
_ the WHEEL
to select CABLE
BOX SET UP.
- - SET UP CHANNEL -_-|
/
ANTENNA SYSTEM : CATV |
AUTO SET |
SELECT : ROTATE WHEEL |
SET : PUSH WHEEL |
END : PUSH MENU KEY |
)
Select YES if all channels
_ are received via the cable
box (.connection "A" at left).
Then, go to step 5.
ARE YOU USING
A CABLE BOX?
YES
Select NO if your cable
connection resembles
connection "B" at left.
Push MENU to exit and turn to page 21.
SELECT : ROTATE WHEEL
SET : PUSH WHEEL
END : PUSH MENU KEY
Cable/
From Antenna Antenna '
orC.O,;
RF Coaxial Cable
(supplied)
••jJ
If your system looks like one of these,
do the following.
1. Skip the "Cable Box Set Up" section
at right and turn to page 21.
2. Complete the "VCR Plus+ Channel Set
Up" section on page 21.
3. Turn to page 22 for VCR Plus+
Programming.
Rotate the WHEEL
to change the
output channel
number.
• Number shown is
example only. Please
be sure to enter your
ENTER CABLE BOX OUTPUT
CHANNEL
SELECT : ROTATE WHEEL
SET : PUSH WHEEL
END : PUSH MENU KEY
cable box output channel.
• If necessary, refer to your cable box manual.
• If you are using AudioNideo jack connection for your cable
box, select and set "VIDEO OUT" as the output channel.
O
MENU
Push MENU to
confirm your entry.
• This display appears for
five seconds. (Channel
shown is e×arnple only)
YOUR TV IS RECEIVING
_c_EoOUTPUT O_ C ASLE _0×
( VCR Plus+ and PlusCode are trademarks of
t Gemstar Development Corporation, 1
The VCR Plus+ system is manufactured under /
license from Gemstar Development Corporation_
Push MENU twice
to return to the
MENU normal screen.
Then,go directly to VCRPlus+
Programmin9 on page 22.
2O