Sony Handycam Vision DCR-TRV9 Operating Instructions Manual page 66

Notes on audio dubbing
• A new sound cannot be recorded on a tape already recorded in the 16 bit mode (32 kHz,
44.1 kHz or 48 kHz).
• When an external micropbone is not connected, the recording will be made through the
built in microphone of tile camcorder.
• A new sound cannot be recorded on a tape already recorded in tile LP mode.
• If you add a new sotmd on a tape recorded witb another camcorder (including DCR
TRV9), tile sound quality *nay become worse.
• When you record a playback pause picture with the DVjack, you cannot add audio to that
portion of tile tape.
• You cannot add audio with the DVjack.
(1) Insert your recorded tape into the camcorder.
(2) While pressing tile small green button on the POWER switch, set it to VTR.
(3) On the camcorder, locate tile point where the recording should begin by pressing _ or
I_-. Then press || to set it to playback pause mode.
(4) Press AUDIO DUB on tile Remote Commander.
(5) Press || on tile Remote Commander and at the same time start playing back tile audio
you want to record. The new sotmd will be recorded in stereo 2. The recorded sound in
stereo 1 is not heard.
(6) Press • on tbe Remote Commander at tile point where you want to stop recording.
To play back the new recorded sound
Adjust the balance hetween the original sound (ST1) and the new sound (ST2) by selecting
AUDIO MIX in menu system.
MENU
AUDIO M_X
ST/ • ST2
[MENU]END
Five minutes after when you disconnect the power source or remove the battery pack, the
settings of AUDIO MIX return to tile original sound (ST1) only. The facto1T setting is
original sotmd only.
To end audio more precisely
First, press ZERO SET MEMORY on the Remote Commander at tile point where you want to
stop recording. Tben start recording fl'om step 2, and tile recording stops automatically *lear
the cotmter's zero point.
66