Rear Panel Layout - Vox NIGHT TRAIN EFGSJ1 Owner's Manual

6. BASS Control - This controls the bass (low) frequencies in your sound - from warm and
light when turned down (counter-clockwise) to dark and heavy when cranked (clockwise)
and all points in between.
7. VOLUME Control - This affects the overall output level of the preamp stage, use this to
control the overall volume of the amplifier whilst retaining all the tonal characteristics. (hey
who, are we kidding here....overdrive!)
8. OP MODE (Output Mode) Switch - This is used in 3 ways:
a. PENTODE - Full 15 Watts of power
b. STBY - No output, just nicely warmed tubes
c. TRIODE - 7.5 Watts output power with a slightly mellowed top end.
9. MAINS Switch - Turns the Night Train from off to on!
10. Indicator - Let's you know if the night train is ....well...on or off!

REAR PANEL LAYOUT

1
2
1. MAINS INPUT - Connect your electricity here with the supplied, detachable Mains (power)
cord.
2. MAINS FUSE - (serious bit) The fuse provides an overall safety protection in the event
your amplifier develops and electrical fault.
The correct value of the fuse is located on the rear panel of your amplifier and should only
be replaced with one of the same value.
3. 8 Ohm Speaker Jack - This is used to connect the Night Train to any 8 ohm cabinet.
4. 16 Ohm Speaker Jack - This is used to connect the Night Train to any 16 ohm cabinet.
WARNING ! Always use a non-screened VOX approved speaker lead with
the Night Train amplifier and cabinet.
WARNING ! Please ensure that your amplifier is connected to the correct
mains power voltage—please check the rear panel rating plate.
If in doubt consult dealer.
WARNING ! NEVER operate this amplifier without the loudspeaker load
being connected. Serious damage can occur otherwise.
WARNING ! This amplifier must always be earthed (grounded) to prevent
the risk of electrical shock.
4
3 4