Uniden MC 610 Owner's Manual page 4

~
CD Channel Selector. . . Selectsthe
desired channel. LEDdisplay shows 01
through 88. All channels are displayed
by two digits, including "a" on the first
digit.
@ Microphone Connector... Re-
ceptacle for microphone connection.
CID O N/OFF VOLUME. . . Turns
power on and adjust the listening level.
Whenever the power is turned on, the
unit automatically goes to Channel 16.
.'
@ SQUELCH.. . Used to silencethe
background noise when no signal is be-
ing received. Turn the knob just past
the point where background noise
stops.
CID DIM/BRIT Selector... Adjusts
the brightness of th~ display.
@ IW/25W Selector... Controls
transmitter output power. Use the 1W
(WATT) position for in-port or short
range communications.
...
(j) CHI6Selector. . . Provides i nstant
tuning to CHi 6 overriding RotaryChan-
nel selector. LEDindicator and Channel
display will indicate when unit is on
Channel 16. When you press "OFF",the
channel will go back to the channel
tuned just before you pressed "CH 16".
The Channel display will go back to that
channel.
@ TXLEDIndicator. . . Glows red in
the transmit mode.
@ CHI6 LED Indicator... Lights
when CH16 SELECTORis activated.
,
@ I WATT LED Indicator. . . Shows
when unit is switched to Low power (1
WATT).
@ LED Channel Display... Indi-
cates channel in use.
CaUTION:
When CH87A is used, LED
channel display shows as 87 , 8 (bigger
than 7) and 7 (smaller than 8) by
comparison.
.