Table of Contents
Advertisement
Although the LX-80 printer has many sophisticated commands to
set margins, line spacing, and horizontal and vertical tabs, we won't
take up your time with extensive discussions of these because most of
these functions are taken care of by applications programs. This chap-
ter merely describes a few commands that the average user might
need. If you want more information, you can find all the commands
in Appendixes B and C.
Margins
The LX-80 allows you to set the left and right margins with simple
ESCape sequences. The left margin command is ESCape "1" followed
by the number of the column you choose for the left margin. The
right margin command is ESCape "Q" followed by the column num-
ber of the right margin you want. For the left margin command, be
sure to use a lowercase letter 1, not the numeral one.
If your word processing program does not allow you to change the
margins, you can send margin commands to your LX-80 with BASIC
or another programming language before you print your documents.
For example, if you prefer wider margins than your word processing
program gives you, run the following BASIC program before print-
ing. This program gives you a left margin of 10 and a right margin of
60, but you can use any numbers you prefer for the margin com-
mands.
Such a program will also allow you to choose the margins you
prefer for program listings. Just remember that once you run a pro-
gram that sets margins, those margins are in effect until you change
them with new margin commands or turn off or reset the printer.
Chapter 7
Page Formatting
55
Advertisement
Table of Contents
