Table of Contents
Advertisement
In each tractor slot are two pegs that fit into the notches on the
tractor fittings. Tilt the tractor back so that the rear notches fit over
the rear pegs. Then tilt the unit forward until it clicks into place.
That's all there is to it.
Now install the paper separator and pull out the paper guide as
shown in Figure E-4. Fit the notches in the bottom corners of the
separator over the pins at the front of the paper slot. The separator
keeps the paper that is coming out of the printer from being pulled
back in. Pull out the paper guide at the back of the printer. This guide
helps keep the incoming paper from catching on the printer cable.
Figure E-4. Paper
separator and
paper guide
E-3
Advertisement
Table of Contents
