Printer Setting Descriptions; Character Spacing; Shape Of Zero; Skip-Over-Perforation - Epson LX-300 User Manual

8. See the appropriate table in your printed instructions. Press
the FONT button to move through the settings in the table. The
printer beeps twice each time you press the FONT button
while in a submenu table.
9. When the control panel lights match your desired setting,
press the PAUSE button to make your selection. The printer
saves the new setting and returns to Table B.
10. Repeat steps 6 through 9 for each additional setting you want
to change, or skip to step 11 to exit the Printer Setting mode.
11. When you are finished, turn the printer off. Any settings you
have made remain in effect until you change them again.

Printer setting descriptions

This section describes all the settings available in the Printer
Setting mode.

Character spacing

When you select 10 cpi, the printer prints 10 characters per inch
(cpi). When you select 12 cpi, it prints 12 characters per inch.

Shape of zero

The printer prints the zero character with a slash (0) when the
setting is on, or no slash (0) when the setting is off.

Skip-over-perforation

When you turn on this feature, the printer skips over the
perforations of continuous paper, providing a 1-inch margin
between the last line printed on one page and the first line printed
on the next. Because most software programs set their own top
and bottom margins, you should use this feature only if your
program does not provide them. This feature does not affect
single-sheet paper.
2-22
Using the Printer