About Your Printer's Default Settings; Understanding Default Settings - Epson LQ 630S Reference Manual

About Your Printer's Default Settings

The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting from
the printer's control panel using the default-setting mode.
For a detailed description of the settings you can change in the
default-setting mode, see "Understanding default settings" on
page 41. For instructions on changing the settings, see "Changing
default settings" on page 47.

Understanding default settings

This section describes the settings and options available in the
default-setting mode. These settings are shown in the following
table and explained in detail after the table.
To access and change a setting, see "Changing default settings"
on page 47.
Default-setting mode
Setting
Page length for tractor
Skip over perforation
Auto tear-off
Auto line feed
Print direction
Software
0 slash
High speed draft
I/F (interface) mode
Auto I/F (interface) wait time
Parallel I/F (interface)
bidirectional mode*
Options (default in bold)
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11, 70/6, 12, 14, 17
Off, On
Off, On
Off, On
Bi-D, Uni-D, Auto
ESC/P2, IBM PPDS
0, (the zero character with a slash)
Off, On
Auto, Parallel,* Serial,** USB
10 seconds, 30 seconds
Off, On
Control Panel
3
3
3
3
3
3
3
3
3
3
3
3
41