Using The Tear-Off Function - Epson LQ 630S Reference Manual

Note:
❏ Always make sure there is at least one more sheet than required;
continuous paper may not feed properly if it is not fed through the
sprockets.
❏ Do not pull the loaded paper out of the tractor unit while the printer
is on. Doing so may cause paper jams or printer malfunctions, also
the top-of-form position setting may become misadjusted.
❏ Do not pull out paper that is not ejected completely after pressing
the Load/Eject button. Doing so may cause paper jams or printer
malfunctions, also the top-of-form position setting may become
misadjusted.
❏ If the first line on your page appears too high or low, you can change
its position by using the Micro Adjust function as described in
"Adjusting the top-of-form position" on page 20.

Using the tear-off function

You can use the tear-off function to advance your continuous
paper to the printer's tear-off edge automatically when you finish
printing. You can then easily tear off the printed sheets. When you
resume printing, the printer automatically feeds the paper back
to the top-of-form position so that you can save the paper
normally lost between documents.
To use the tear-off function, turn on the Auto tear-off function and
select the appropriate page length for continuous paper in the
default-setting mode. See "Changing default settings" on page 47
for instructions on how to change the default settings.
If the perforation between pages is not aligned with the tear-off
edge, you can adjust the position of the perforation using the
Micro Adjust function. See "Adjusting the tear-off position" on
page 19 for more information.
When Auto tear-off is on, the printer automatically advances the
paper to the tear-off position whenever it receives a full page of
data or a form feed command followed by no more data.
The steps below describe how to use Auto tear-off function.
10
Paper Handling