Installation - Tripp Lite OMNIPOWER PRO550 Owner's Manual

Installation

Input Connection
1
Connect the UPS to a grounded 120V AC
outlet. Ensure that the outlet does not share
a circuit with a heavy electrical load (e.g. air
conditioner or refrigerator).
Power On
2
Press the ON/OFF/TEST/MUTE button
for 1 second (the UPS will beep) to turn the
UPS system on. The green ON/OFF light
will illuminate when the UPS system is on.
Note: The UPS system will not begin to charge its battery
until it has been turned on. Connected equipment will not
be supported adequately during a power failure until the
internal battery has charged for 4-6 hours. It will take up
to 8 hours for the battery to charge completely.
Output Connections
3
Plug your equipment into the UPS outlets.
Note: Laser printers, large household appliances or other
equipment with very high power requirements should not
be connected to the UPS. The UPS will become overloaded
if the combined power requirement for all connected
equipment exceeds the total output capacity of the UPS
(550VA). The VA rating for each piece of equipment can
be found by consulting the equipment's documentation
and/or nameplate. If amps are shown, multiply by 120V to
determine VA (Volts x Amps = VA).
1
A
B
2
3
3
A
B