Basic Operation; Turning On And Off The Tv; Choosing Tv Channel - ProScan 26LB30Q User Manual

Basicoperation- ChoosingTV Channel
TURN ON LCD TV
1. Connect the AC input cable to power the LCD TV. At this time the TV will enter standby mode and indicator show red.
2. User POWER button or button on the remote control.
TURN OFF LCD TV
1. Press POWER button or _ button on the remote control to enter standby mode. The indicator is red.
2. Wait 5 second after switch off LCD TV then you can turn on LCD TV again.
1.
2.
3.
Using the CH + / CH - on the side panel or on the remote control.
• Press CH + to increase channel number.
• Press CH - to decrease channel number.
• When no OSD menu is used, the arrow keys A / T can also work as CH + / CH - buttons.
Using 0-9 digital buttons and - button.
You can select the channel number by pressing 0 to 9.
For example:
IN ANALOG SIGNAL:
To select channel (e.g. Channel 22): Press 2 -> 2 ->ENTER, it will jump to 22-0 directly.
IN DIGITAL SIGNAL:
To select digit channel (e.g. Channel 22-1 ): Press 2 -> 2 -> - > 1 ->ENTER, the program will appear immediately.
NOTE: Sub channel number of analog channel is always zero. But when you in the digital signal, if you enter
physical channel number and not end with "ENTER", channel selection will be made if there is no
operation within a few seconds.
]4