Gigabyte GA-7VT600 User Manual page 68

After BIOS file is read, you'll see a confirmation dialog box asking you "Are you sure to update
BIOS?"
Boot From......................................... Main Bios
Main ROM Type/Size........................
Backup ROM Type/Size....................
Wide Range Protection Disable
Boot From Main Bios
Auto Recovery Enable
Halt On Error Disable
CHECKSUM = 96D2
Copy Main ROM Data to Backup
Are you sure to update BIOS?
Load Default Settings
Save Settings to CMOS
[Enter] to continue or [Esc] to abort.....
Load Main BIOS from Floppy
Load Backup BIOS from Floppy
Save Main BIOS to Floppy
Save Backup BIOS to Floppy
Enter : Run :Move
3. Press Y button on your keyboard after you are sure to update BIOS.
Then it will begin to update BIOS. The progress of updating BIOS will be displayed.
Boot From......................................... Main Bios
Main ROM Type/Size........................
Backup ROM Type/Size....................
Wide Range Protection Disable
Boot From Main Bios
Auto Recovery Enable
Programming Now.......
Halt On Error
>>>>>>>>>>>>......................
Copy Main ROM Data to Backup
Load Default Settings
Don't Turn Off Power Or Reset System
Save Settings to CMOS
Load Main BIOS from Floppy
Load Backup BIOS from Floppy
Save Main BIOS to Floppy
Save Backup BIOS to Floppy
Enter : Run :Move
Please do not take out the floppy disk when it begins flashing BIOS.
GA-7VT600(-L) Motherboard
Dual BIOS Utility
SST 49LF003A
SST 49LF003A
Q-Flash Utility
ESC:Reset F10:Power Off
Dual BIOS Utility
SST 49LF003A
SST 49LF003A
Disable
Q-Flash Utility
ESC:Reset F10:Power Off
- 64 -
256K
256K
You can press "Enter" to continue
updating BIOS or "ESC" to abort.
256K
256K
The progress of updating BIOS.
Do not turning off power or reset
your system at this stage to avoid
damaging your BIOS rom!!