Installation Instructions - Guidelines - Belling IFF5050FF Installation And User Instructions Manual

Table of Contents

Advertisement

INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. See for detailed Installation Instructions including reversing door opening
direction.
3.This appliance has been designed to operate in ambient temperatures up
to 32 degrees C (90 degrees F) and is equipped with Advanced Electronic
Temperature Control System [AETCS] which ensures that at the advised setting
[4 - four on the knob] the frozen food in the freezer will not defrost even if the
ambient temperature falls as low as -15 C. When first installed the product
MUST NOT be placed in low ambient temperatures because the freezer will
not reduce to it's standard operating temperature. Once it has reached its
steady operating state it can be re-located. So you may then install your
appliance in a garage or an unheated room without having to worry about
frozen food in the freezer being spoilt. However at low ambient temperatures
mentioned above, fridge contents are likely to freeze, so check and consume
food in the fridge accordingly. When the ambient temperature returns to normal,
you may change the knob setting to suit your needs.
If the ambient temperature is below 0 C, the food in the fridge compartment
will freeze. So, we recommend you don't use the fridge compartment in such
low ambient conditions. You can continue using the freezer compartment as
usual.
4. Do not place the appliance near cookers, radiators or in direct sunlight as
this will cause your appliance to work harder. If installed next to a source of
heat or freezer, maintain the following minimum side clearances:
From Cookers
From Radiators
From Freezers
5. Refer to cleaning and care section to prepare your appliance for use.
A special receptacle is supplied to store the
6.
mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the side of the compressor.
(See diagram) Gently remove the plug from
the receptacle. Never pull the mains cord, you
may damage the appliance. In the case of
transportation,ensure you locate the plug in
the receptacle provided to avoid transit
damage.
50 mm (2")
300 mm (12")
25 mm (1")
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Be817

Table of Contents