Sony Handycam CCD-TR2300 Service Manual page 19

?
You can insert a scene in the middle of a recorded tape by setting the starting and
ending points. The previous recorded portion will be erased. If the RC time code
appears in the viewfinder, set COUNTER to NORMAL in the menu system to display
the tape counter.
(1) While the'camcgrder is in Standby mode, keep pressing the + (forward
playback) or - (reverse playback) side of EDITSEARCH0 and release the button
where you want to end the insertion [b]. The camcorder enters Standby mode
again.
(2) Press COUNTER RESET. The counter resets to zero.
(3) Keep pressing the - side of EDITSEARCH and release the button at the point
where you want to start the insertion [a].
(4) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes.
(5) Press START/STOP to start recording. The recording stops automatically at
the counter zero point.
[a] --_ 4r" [b]
b
r21
1
_ _Jb ÷ EOITSEARCH --
To change the end point
Press ZERO MEM to erase the ZERO MEM indicator, then repeat steps 2 to 5.
Note an re-recording
The picture and the sound may be distorted at the end of the inserted portion when it is
p[ayed back.
Selecting the desired mode
You can record a cinemalike picture (CINEMA) or a 16:9 wide picture to watch on the
16:9 wide-screen TV (16:9 FULL).
[b]
16.'9 FULL
[d]
16:9 FULL
CINEMA
Blackbands appearatthetopand thebottom ofthescreen, a nd theviewfinder [ a]and
a normal TV screen[hilookwide.You can also watch thepicture w ithoutblackbands
on a wide-screen TV [¢].
16:9 FULL
The picture in the viewfinder [all or on a normal TV [el is horizontally compressed. You
can watch the picture of normal images on a wide-screen TV [f].
While the camcorder is in Standby mode, press 16:9WIDE repeatedly so that the desired
mode indicator appears in the viewfinder.
16:9WIDE
CINEMA 1
J
o
38 39