Sony BRAVlA KDL-32XBR4 Operating Instructions Manual page 33

Auto Wide
4:3 Default
Select thed@mlt ._creen
mode to use,/_)r 4:3
SOIIFCUS
Display Area
Screen Position
Vertical Size
On Automatically changes Wide Mode setting based upon content. If
frequent screen changes are disturbing to yon, select Off.
Off Tnrns off the Auto Wide option.
Choose
a Wide Mode
from the
Wide Mode option.
Wide Zoom Enlarges the 4:3 picture to fill tile 1(,:9 screen, disphtying as much of
the original inaage as possible.
Normal Displays the 4:3 picture in its original aspect ratio.
Full Select to enlarge the 4:3 picture horizontally only, to fill the screen.
Zoom
Select to enlarge the picture horizontally and vertically to fill the
screen while maintaining the aspect ratio.
Off
Select to continue using the current
Wide Mode
setting when the
channel or input is changed.
• This option is not available if Auto Wide is set to Off.
• If4:3 Default is set to anything but Off, the Wide Mode setting applies only to the
current channel. When you change channels (or inputs), Wide Mode is automatically
replaced with the 4:3 Default setting for 4:3 sources. To retain the cnrrent Wide Mode
setting as channels and inputs are changed, set 4:3 Default to Off.
Normal
Displays the picture in its original size.
-1/-2 Enlarges the pictnre to hide the edge of the pictnre.
Adjust the Vertical positioning by pressing the 11411, b uttons. Press the 14. buttons to
adjust the
Horizontal
positioning.
• Screen Position option is available tbr standard-definition signals only. Vertical
adjnstment is a'_ailable only when Wide Mode is set to Zoom.
• Screen Position feature is useful if the TV is connected to game equipment.
Adjusts the vertical size of the picture. (Available only in Wide Zoom and Zoom.)
Press 14. and press @ to ac[iust.
2
"d
Auto
Adjust
Select Yes to start the auto a@lst
to display the PC input.
Reset Resets the current screen settings to the default valnes.
Phase Ac[inst alter Pitch to fine tune overall sharpness.
Pitch
Adjust uneven sharpness on screen.
• For the PC input Signal Reference Chart, see page 18.
H Center
Allows you to move the position of the picture horizontally (left and right).
To Adjust the H Center
Press tl./,1!,to highlight
H Center
and press @.
Press 14. to correct the centering then press @.
V Center Allows you to move the position of the picture vertically (up and down).
To Adjust the V Center
Press tl./,1!,to highlight V Center al:ld press @.
Press 14. to correct the centering then press @.
(Continued)
33