Sony KE-32TS2U Operating Instructions Manual page 52

Adjusting Your Setup
Menu category Menu item Setting option
_._ Screen Zoom Select to enlarge the picture with the center position fixed (only when "Wide Mode" is set
to "Full"). Select from "Standard" (normal size), "x2" (doubled), "x3" (tripled), or "x4"
(quadrupled).
Screen Adjust Pixe[ Select Io adjust the picture fi'om an RGB equipment.
Control
_] Display
Screen Saver
Cuslom Setup
Auto Adjust: Select "OK" to make best possible adjustment for the input signal
aulomalically. Note that it may no1 be adjusled perfectly depending on the
input signal condition or picture paltern. In this case, perform "Aulo Adjust"
again.
Dot Phase: Adjust in the range of "01" -"62" if pm't of a displayed text or image is no1 clear.
"I%tal H Pixel (Total Horizontal Pixel): Adjust when the letter or picture is not clear as a
whole.
Color Malrix
RGB Mode
Reset: Reset to the factory seldngs.
Select "On" to display which input is selected.
Select Io reduce image retention.
Pic. Orbit (Picture Orbit) (To prevent image retention)
Move 1he picture position 1o reduce image retention. This does no1 prevent image
retention complelely if the same picture is displayed for an extended period of time.
Orbit: Select "On" or "Off" Io set the Pie. Orbit. The factory setting is "On."
A slop-start moving picture goes around the screen edge (one cycle per hour).
The picture shifts a little once every one to two minutes. This is because the
"Orbit" option is set to "On" to prevent image retention. When the "Orbit"
oplion is set to "Off," note that displaying the same patterned signals or 4.3
aspect ratio pictures for a long time may result in image retention.
Select 1o give the picture a neulral tint, if the oulput signal from the DVD player
connected to the VIDEO IN 4 jacks is 525p (480p), 1125i (1080i), or 750p (720p) signal
format. Adjust this only when the picture tint goes out of tune. Select the signal formal for
each input, then set it to "Y/CdG," or "Y/Pb/P,." When purchasing, all formals are set Io
"Y/Pb/P,."
Select if an equipment which outputs the RGB signal is connected to the Y/G, P[dB, P[dR
jacks of the VIDEO IN 4 jacks.
Sync Mode
D_: Select when a digital tuner with RGB signal is connected.
Others: Select when other RGB equipment is connected.
Set according 1o the input signal from the HD jack of the VIDEO IN 4 jacks.
H/Comp: Select when the input signal is a horizontal synchronized signal or a composite
signal.
Video: Select when the input signal is a video signal.
52 (us)