Sony KE-32TS2U Operating Instructions Manual page 4

Antenna Grounding According to the NEC
Refer to section 54-300 of Canadian Electrical Code for Antenna Grom_dlng.
._ Antenna lead-in wire
" Ground clam/_ i
Antenna discharge unit
_ 2_-_ (NEC Section 810-20)
Electrical wire /
Ground clamps
- Antenna lead-in wire
÷_- - Power service grounding electrode
system (N£C Art 250 Part H)
NEC: National Electrical Code
Lightning
For added protection for this television receiver durlng a lightning storm, or
when it is left unattended and unused for long periods of time, unplug it
from the wall outlet and disconnect the antenna. This will pwvent damage
to the receiver due to fight nhlg and powePline surges,
Image retention
An image retention or ghost may appear on screen of the set if it a static
image is displayed on the screen for a period of time. ']b avoid this problem,
the "4:3 Default" or "Restore" mode should be used.
Refer to the operating instructions if an image PPtention or ghost appears.
Service
Damage Requiring Service
Unplug the set from the wall outlet and refer servicing to quallfied service
personnel under the following conditions:
[] When the power cord or plug is damaged or
frayed. @_x _
[] If liquid has been spilled into the set.
[] If the set has been exposed to rain or water.
[] If the set has been subject to excessive shock by being dropped, or the
cabinet has been damaged.
[] If the set does not operate normally when following
the operating instructions. Adjust only tfiose controls
that are specified in the operating instructions.
Improper adjustment of other controls may result in
damage and will often require extensive work by a
qualified technician to restore the set to normal
operation.
[] When the set exhibits a distinct change in performance,
it indicates a need for service.
Servicing
Do not attempt to service the set yourself since opening the
cabinet may expose you to dangerous voltage or other
hazards. Refor all servicing to qualified service personnel.
Replacement
Parts
When replacement parts a_ required, be sure the service technician certifies
in writing that he has used replacement parts specified by the manufacturer
that have the same characteristics as tile original parts.
Unauthorized substitutions may result in fire, electric shock or other
hazards.
Safety Check
Upon cOnlpletion of any service or repairs to the set,
ask the service technician to perform routine safoty
checks (as specified by the nlanUfactm_r) to
determine that the set is in safe operating condition,
and to so certify. When the set reaches the end of its
useful life, improper disposal could result in a
picture tube implosion. Ask a qualified service
technician to dispose of the set.
Important Safety Instruction
1) Read these il_structions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5)
6)
7)
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the
manufacturer's il_structions.
8) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or tile third prong are provided for your sa fet)a If the
provided plug does not fit into your outlet, consult an elechician for
replacement of the obs_)lete outlet.
10) Protect the power cord from being walked on or pinched particularly
at plugs, convenience receptacles, and tile point where they exit from
the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, brackeb or table specified by the
manufacturer, or sold with the apparatus. When a cart is uscKI, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
13) Unplug thls apparatus during lighh_ing storms or when unused for
long periods of time.
14) Refer all sen, icing to qualified service personnel. ,qervicing is requiped
when the apparatus has be'en damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or obiects have
fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
4 (us)