Connecting A Vcr And Cable - Sony KE-32TS2U Operating Instructions Manual

Installing and Connecting the TV
Connecting a VCR and Cable
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the cable TV cable to the VCR's IN.jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT.jack
to the TV's VHF/UHF jack.
3 Using AUDIO and S VIDEO cables, connect the VCR' s Audio and S Video
OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
Rear of TV
AUDIO-R (red) !!_
AUDIO-L (white)
VIDEO (yellow)
-- S VIDEO VCR
VMC-810S/820S
(not supplied)
75-ohm
coaxial cable
(supplied)
YC-15V/30V (not supplied)
1 0 (us)
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cane (yellow) instead of the S
VIDEO cane.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. You can set it for each video input (VIDEO IN 1 and VIDEO IN 2)
separately. The TV is factory set to receive S VIDEO input signals.
1
Press TV/VIDEO repeatedly until the desired video input appears.
2 Press MENU.
3 Press tt/,l, to select _ (Custom Setup), then press (_).
4 Press tt/,l, to select "Auto YC," then press (i).
5 To watch the pictures input from the S VIDEO input jack:
Press tt/,l, to select "On," then press C_).
To watch the picture input from the VIDEO input jack:
Press tt/,l, to select "Off," then press (Z).
6 Press MENU to exit the menu screen.