Parental Lock Settings; General Settings; Replacing The Lamp - Sony KDF-37H1000 Operating Instructions Manual

Lost password • Select the Password settings on the Parental Lock settings, then enter the
I_llowing master password: 4357. The master password clears your previous
password and allows you to enter a new password (see page 35).
How to reset the TV to • Turn on the TV. While hokting down 4" on the remote control, press POWER
factory settings on the TV. (The TV will turn itself off. then back on again.) Release ,l..
WARNING: The Reset will clear all of your customized settings including the
Parental Lock setting.
LAMP LED blinks in red • Replace the lamp (see page 39).
'%amp Replacement • It is time for you to replace the projection hunp used in you TV.
message" appears • Trim to page 39 on "How to Replace the Lamp" and follow the directions on
replacing the lamp.
• Use only the lamp designated for your TV model.
• After the lamp is replaced, select the Lamp Replacement option in the
General settings.
The replacement lamp does • The lamp door or lamp might not be securely attached. Repeat the steps on page
not light np 39 to ensure that they are both installed securely.
The cooling fan is loud • If the TV is nsed at high altitudes and the
Cooling
Mode is set to High, the
cooling fan runs faster and its sound becomes louder. If the TV is not used at
high altitudes, set
Cooling
Mode to Normal (see page 38).
"'High Temperatnre • Make sure to remove dust from the ventilation slots on the rear and both sides of
Warning!" message appears the TV. In addition, make sure that there are no obstacles in front of the
ventilation slots. If the message still appears after the dust or obstacles are
removed, the TV may need servicing. Call your local Sony Service Center.
hnage left on the screen •Tnm off the TV for a while or let the TV run on another channel. Unlike plasma
(image retention) TV and CRT TV. image retention on this TV is not permanent. It is only a
temporary condition (see page 10).
White spot on the screen • If screen is exposed to direct snnlight or strong ambient light, part of the screen
when powered off may appear white even when TV is power off. This is dne to the strong light
reflecting off the TV screen and reflections coming from behind the screen.
This is a structural property of the projection TV and is not a defect.
• Position your TV away from such light sources.
44