Important Safety Instructions - Sony KDF-37H1000 Operating Instructions Manual

Important
Safety
Instructions
1_ Read these instructions.
2) Keep these instructions.
3 b Heed all warnings•
41 Follow- all instructions,
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
12 } Use only with the cart, stand, tripod, .__ .._..
bracket, or table specified by the _"
manufacturer, or sold with the _v_
apparatus. When a cart is used. use
ca ution when moving the care _I_
apparatus combination to avoid injury _
from tip-over.
13) Unplug this apparatus during (7:g_
lightning storms or when unused =7] _/_
for long periods of time.
141 Refer all servicing to qualified
service personnel. Servicing is _ ___
required when the apparatus has been _
damaged in any way, such as --@"_3
power-supply cord or plug is
damaged, liquid has been spillea or
objects have fallen into the apparatus, (-_
the apparatus has been exposed to _==_-
rain or moisture, does not operate _t.__j
normally, or has been dropped.
7_ Do not block any ventilation
openings. Install in accordance with
the lmmufacturer's instructions.
[] Be sure to obseiwe the TV's "For Sat?ty" section on page 5.
Antennas
Outdoor Antenna Grounding
4_ If an outcloor antenna is installed. Ibllow the precauUons below, An
outdoor antcnna system should not be located in the vicinity of overheaa
powerlines or otherelectric light or power circuits, or where it can x_me
. in confac[ with stlcn power lines or circtliis.
8) Do not mstall near any heat sources , ,t,_,t ,,_.
• . 2,_L"r_ WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM.
such as radmtors, heat registers,
' 5 • " ' _ .' " _ ._ EXTREME CARE SHOULDBE TAKEN TO KEEP FROM
stoves, or other apparatus (including ' CONTACTINGSUCH POWER LINES OR C1RCUITSAS CONTACT
amplifiers) that produce heat, WITH THEM 1SALMOST INVARIABLY FATAL.
9) Do not defeat the safety- purpose of
the polarized or grounding-type
plug. A polarized plug has two
blades with one wider than the other. _'_ ._,o
A grounding type plug has two H_'Q_ "_,
blades and a third grounding prong. ,_\
The wide bl ade or the third prong are
provided for your safety. If the
provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.
10_ Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and _
the point where they exit from the
apparatus.
11) Only use attachments/accessories
specified by the manufacturer. (s_ _)
Be sum the anfenna sy S[_lil i8 grounaea so as 1o proviae 5olne protection
against voltage surges and built-up static cnarges.
Section 810 of the National Elcctrical Code INEC_ in USA and Section
54 of the Canadian Electrical Code in Canada provides intbrmation with
l_spect to proper grounding of the mast and supporting structure.
grounding of the lead-in wire to an antenna dischm'=e unto size or
grounding conductors, location of antenna discharge unit. connection to
groundin_ electrodes aim requirements lbr the grounding elccu'oae
Antenna Grounding According to the NEC
RotOr to section 54-300 of Canadian Electrical Code tor Antenna
Grounding.
Antenna lead-in wire
Ground cla
___,f,¢ / [ ' _ Antenna discharge unl_
I E:eC[c_iCa'--'---'-_J J
_"_ I (NEC Section
810-20_
I eauicrnent_ J_ _ _JGroueding conductor_
__.¢J_ (NEC section 810-21)
I _- Ground clamps
"_-_,_.__ Powerservice grounding
NEC: Nationa electrode system (NEC Art
Electrical Code 250 Part H)
4