Weider Pro 340L User Manual page 8

5. 5
Orient the Backrest Frames (16) so that the
welded tubes are in the positions shown.
Apply a small amount of the included grease to
an M10 x 180mm Bolt (43). Attach the Backrest
Brace (15) to the Backrest Frames (16) with the
Bolt, two M10 Washers (35), and an M10
Locknut (37). Do not tighten the Locknut yet.
Orient the Backrest (19) as shown.
Attach the Backrest (19) to the Backrest
Frames (16) with four M6 x 48mm Screws (41)
and four M6 Washers (42). Do not tighten the
Screws yet.
43
Grease
I
19
16
35
_37
.
Apply a small amount of grease to an M10 x
180mm Bolt (43). Attach the Backrest Frames
(16) to the Frame (1) with the Bolt, two M10
Washers (35), and an M10 Locknut (37). Do
not overtighten the Locknut; the Backrest
Frames should pivot easily.
Insert the end of the Backrest Brace (15)into
one of the slots in the Frame (1).
See step 5. Tighten the M10 Locknut (37)
and the four M6 × 48ram Screws (41). Do not
overtighten the Locknut; the Backrest Brace
(15) should pivot easily.
43
Grea_se
35
5
... 35
Slot
1
.
Apply a small amount of grease to an M10 x
82mm Bolt (45). Attach the Leg Lever (5) to the
Front Leg (4) with the Bolt and an M10 Locknut
(37). Do not overtighten the Locknut; the
Leg Lever should pivot easily.
Attach the Weight Clip (8) to the weight tube on
the Leg Lever (5).
5
37
4
Grease
8