.
.
_::
,#:_ ...................
_
...............................
: .............................
m: m ......................................................
................. ...........
o atA semb,y .............................
i!iiiiiiii!iiiiiiiiiiiiiii!ili::!ili!!iii_iiii!ii!i_iiii!iiiiiiiil
_ i
iii!:
_
ii!i_!ili:iriiii!i!iiiiiiiii!ili_ili_i!iii_i:_i_iii!ii;ili:i!ii!!iiiilililill
33. Locateandopenthepa:tsbaglabeled"SEAT
ASSEMBLY."
Insert a 1/4" x 2" Carriage Bolt (85) through the cen-
ter hole in a Seat Plate (42). Attach the Seat Plate to
a Seat (51) with two 1/4" x 3/4" Screws (13).
Insert the 1/4" x 2" Carriage Bolt (85) into the indicat-
ed hole in the Press Seat Frame (52) and secure it
with a 1/4" Flat Washer (11) and a 1/4" Nylon Locknut
(16). Secure the other end of the Seat (51) with a 1/4"
x 2" Bolt (86) and a 1/4" Fiat Washer (11).
34. Press four 3/4" Round Inner Caps (40) into the ends
of the Pad Tubes (48) and the indicated tubes on the
Leg Lever (49) and the Press Seat Frame (52).
Insert the Pad Tubes (48) into the indicated holes in
the Leg Lever (49) and the Press Seat Frame (52).
Slide Foam Pads (47) onto the ends of the Pad
Tubes.
51
11
85
-42
52
34
4O
p_
35. Insert a 1/4" x 2 1/2" Cardage Bolt (12) through the
center hole in a Seat Plate (42). Attach the Seat Plate
to the Press Backrest (89) with two 1/4" x 314" Screws
(13).
Insert the 1/4" x 2 1/2" Cardage Bolt (12) with a 1/4"
Flat Washer (11) into the indicated hole in the Press
Frame Upright (59) and secure it with a 1/4" Nylon
Locknut (16).
Secure the other end of the Press Backrest (89) with
a 114"x 2 112" Screw (10) and a t/4" Flat Washer
bl).
42
89
16