Programming For Dbs System - GE RM94925 Instruction Manual

94925 Revised Size 2/25/02
Programming For DBS Satellite System
Most GE, RCAand ProScan Satellite systems will not
require programming. Check to see if your DBS
Satellite system responds to the remote before you
begin programming.
1. Manually turn on the
DBS system. Find the three
digit code for your DBS
system in the code list
below.
2. Press and hold the
CODESEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE SEARCH
button.
3. Press and release the
DBS button (The INDICA-
TOR LIGHT will blink then
remain lit.
4. Enter the code using the
Number Buttons. After your
code is entered, the INDI-
CATOR LIGHT will turn off.
If the code is not valid, the
INDICATOR LIGHT will
blink. Check the code list
and repeat process.
5. Aim the remote at your
DBS system and press the
ON•OFF button. Your DBS
system should turn off.
6. With your DBS System
on, press CHAN+ (CHAN-
NELUP). If the satellite sys-
tem responds, no further
programming is required.
NOTE: If your DBS system does not respond, try all
the codes for your brand. If the codes do not work,
or your brand is not listed, try the Code Search
method on Page 16.
7. Enter your code here for easy reference.
SATELLITE CODE LIST
4:00 PM Page 9
8