Table of Contents
Advertisement
Set the audio output in two main stages: (i) Selecting
the audio mix
(ii) Choosing
the output channel
(i) Selecting
the
audio
mix
When you play back a tape that was recorded
in 12 bit mode, you call select tile output:
Stereo 1, Stereo 2, or a mixture
of the two.
• Audio from the 16 bit mode only contains
stereo 1 sound and so you cannot/do
not need to select the
audio mix. The same is true for the 12 bit stereo
1 mode, unless new sound has been added post-
recording.
Go directly
to stage (ii).
• You only need to release the fixed level (step 2) if your aim is to mix the balance.
o
1. Set the camera
to VCR
mode.
2. Release
the fixed
level (for
audio
mixing
only).
(seep.
18) _
),MIX
SELECT..VARIABLE
a) ()pen the VCR menu and point the arrow at MIX SELECT.
b) Select the VARIABLE
setting and close the menu.
3. Choose
the output.
a) Press the AUDIO
MONITOR
button to display
"STEREO1",
"STEREO2",
and "MIX",
each in
turn.
• Your choice is selected a few seconds after you
last pressed the button.
STEREO1
€
If you choose "MIX" you can go on to mix the balance.
• Use the & / T cursor keys to choose the mix balance.
(or the ST-I/ST-2
MIX BALANCE
buttons
on the remote control).
'_
STEREO2
_
MIX
I
6O
Advertisement
Table of Contents
